Create "2by2_unit" Layout
If you have not created the "basic_unit" layout yet, please click
here.
Now that we need to use "basic_unit" to build a "2by2_unit" layout.
Then we will build a mesh using "2by2_unit" layout. This tutorial is process independent. However if you choose to skip steps, pre-created tutorial Pcells exists in hp_cds (MOSIS HP
0.5um process).
Part I. Create "basic_unit" layout
Part II. Use "basic_unit" to create "2by2_unit" layout
Next: Create a mesh layout with "2by2_unit" layout
Part II. Create "2by2_unit" layout
- Start with a new layout cell view "2by2_unit".
Please refer to Layout
Edit Help on how to create a new layout.
- In layout window, click Instance icon, a Create Instance
window will pop up:
Type in "basic_unit" in cell input.
- In layout window, carefully left click at x=2.0, y=0 to position the first
instance of "basic_unit" at x=0.0, y=0.0
- Click Zoon Out icon to zoom out. Then carefully left click at x=36.0,
y=36.0 to position the second instance of "basic_unit" at
x=36.0, y=36.0
- The third instance needs to be rotate 90 degrees.
- In layout window, carefully left click at x=38.0, y=36.0 to position the
third instance of "basic_unit" at x=38.0, y=36.0
- Similarly, place the fourth rotated "basic_unit" instance at:
x=74.0, y=0.0
- Save your layout. We are done with "2by2_unit" layout.
Now that we can proceed to create "test_mesh" layout using
"2by2_unit" cell we just created.
Created September 17, 2001 by Kai He at khe@ece.cmu.edu